v1.4.0

[EvanMulawski]

New Devices

• Additional Hydro AIO models (Hydro Asetek and Hydro Asetek Pro): H80i GT, H80i GT V2, H80i Pro, H100i GT V2, H100i GTX, H100i Pro, H110i GT V2, H110i GTX, H115i Pro, H150i Pro
  • Note: Communication with an Asetek Hydro AIO requires driver installation. Instructions are provided in Corsair-SiUsbXpress-Driver/README.txt.

Existing Devices

• Hydro Platinum: Implemented device communication improvements and fixed "CRC mismatch" errors ("CRC mismatch" error appearing in log for Hydro Platinum devices #47).
• Hydro Platinum: Fixes an issue where some devices, especially Elite models, fail to respond to state reads after writing cooling data (Hydro Platinum Elite models not responding #93).

Other

• General: Presents an alert if (10) consecutive attempts to refresh devices have failed. Like existing alerts, this can be disabled by setting the FANCONTROL_CORSAIRLINK_ERROR_NOTIFICATIONS_DISABLED environment variable to 1 and restarting Fan Control.
• General: Reset the error detection count periodically. Old and/or sporadic errors will no longer trigger the "multiple errors detected" alert.
• Logging: Consolidated device refresh failure messages into a single ERR message instead of two messages (one WRN and one ERR).
• Internals: Set the read and write timeout values for HID devices to 500ms (previously 3,000ms, the default).

---

This discussion was created from the release v1.4.0.