Nessionator, the RGB mod NES output board complement for Tim Worthington's NesRGB board
In order to preserve the Nintendo Entertainment System some actions are required like the recapping of the components cleaning, etc..., one way to ensure compatibility with modern TVs and improve the image as well is by installing the Tim Worthington's NESRGB board, which interfaces between the PPU and a CPLD to convert digital into analog signals with multiple palettes.
This is intended to be a PCB to use with the Tim Worthington's RGB board with a standard NES from regions USA and Europe without having to do any holes on the case.
This board uses a standard Sega Megadrive 2 RGB cable (Sega Genesis).
No cut is required on the case, so we left the outside of the console untouched.
In the BOM directory there's an interactive BOM with all the required components.
In the gerbers directory we have the gerbers to manufacture the boards.
In the KiCAD folder we can find the KiCAD project itself.
You can find here as well the MD2 cable schematics inside.
1- Send to manufacture the GERBER board to JLCPCB or other PCB manufacturer.
2- Get the components required, you can see here the Bill Of Materials BOM
3- Solder the components.
4- Desolder the RF from the NES but save the header pins connecting the mainboard to the RF board.
5- Follow Tim Wothington's install guide here but do not cut the case!!!: Guide
6- Follow this soldering guide:
At this stage you should have something like this:
This is a pic with the NESRGB installed for NTSC 60Hz, check the manual for PAL.
Remember to bridge the output 75 ohm resistors as the MD2 cable already has them inside.
- Be careful with the DCDC switching supply IC
I know, not the best shot showing the RGB.
And yes, read below, no responsibility taken on bad use.
See LICENSE fo more information.