Ability to specify Scoop Radius #17
Closed
granthworth
started this conversation in
Ideas
Replies: 2 comments
-
|
Hi, as a quick solution I can suggest generating bin with scoop and then editing the radius in the timeline, that might be easier. I'll see if I can expose scoop radius, probably it's time to consider an extra settings section like "advance settings" or something to avoid amount of parameters getting out of control |
Beta Was this translation helpful? Give feedback.
0 replies
-
|
was added in this PR #27 |
Beta Was this translation helpful? Give feedback.
0 replies
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
-
In order to save filament, a smaller scoop radius could be calculated by entering a height unit or percentage of the total bin height. I have found myself generating bins with no scoop, deleting 3 bottom inside corner radii in each compartment, and then specifying my own scoop radius with a new fillet. No big deal if this is complicated to implement. Thanks for your hard work!
Beta Was this translation helpful? Give feedback.
All reactions