Cap quality for lower items?

[tlai34]

Hi,
Is there a way for the solver to stop once it hits max quality for the item? Atm it keeps on going until it runs out of CP regardless of the max quality, so you get 10000/2000 quality for example. This way there'll be less steps required. Otherwise would an existing option already do this?

[CoupDeKai]

Since the example you give is that a macro could require fewer steps if it didn't exceed the quality by as much then there is an existing option that might do what you want. In the Solver tab of Options there is a Limit Maximum Length setting that is off by default. If you set this to something small like 5 it'll go for the best quality possible in that number of steps. It might still go over, but at least it'll run a lot faster.

[tlai34]

Hi,
I tried setting it to max length = 5, however, it gave me something 14 steps? Does it work properly?