Skip to content

Latest commit

 

History

History

Sonoff_Basic

Folders and files

NameName
Last commit message
Last commit date

parent directory

..
images
images
 
 
README.md
README.md
 
 
Sonoff_Basic.ino
Sonoff_Basic.ino
 
 

README.md

Itead Sonoff

Alternative firmware

Alternative firmware for Itead Sonoff switches, based on the MQTT protocol and a TLS connection. Sonoff is a small ESP8266 based module, that can toggle mains power and costs only $4.85. More information can be found here.

Features

  • Wi-Fi credentials configuration using WiFiManager
  • Web configuration portal to setup MQTT username, password, broker IP address and port
  • TLS support for CloudMQTT. For any other MQTT brokers, you need to change:
    • broker: IP address of the MQTT broker, and
    • fingerprint: Fingerprint of its certificate (openssl x509 -fingerprint -in <certificate>.crt)
  • Onboard button:
    • Short press: Toggle the state of the relay
    • Medium press: Restart the relay (~3 [s])
    • Long press: Reset the relay
  • PIR motion sensor support. Make sure to connect your sensor on GPIO14

Steps

  • Connect the Sonoff to a FTDI adapter and hold down the button, while powering it (programing mode)
  • Upload the firmware with the Arduino IDE (use the settings below)
  • Connect to the new Wi-Fi AP and memorize its name (1)
  • Select Configure WiFi(2)
  • Choose your network (3) and enter your MQTT username, password, broker IP address and broker port (4)
  • Update your configuration in your home automation system. An example for Home Assistantis available below

Settings for the Arduino IDE

Parameter Value
Board Generic ESP8266 Module
Flash Mode DIO
Flash Frequency 40 MHz
Upload Using Serial
CPU Frequency 80 MHz
Flash Size 512K (64K SPIFFS)
Reset Method ck
Upload Speed 115200
Port COMX, /dev/ttyUSB0, etc.

Wi-Fi and MQTT Configuration

Steps

MQTT topics

# Topic Payload
State <Chip_ID>/switch/state ON/OFF
Command <Chip_ID>/switch/switch ON/OFF

Configuration (Home Assistant)

configuration.yaml :

switch:
  platform: mqtt
  name: 'Switch'
  state_topic: 'CBF777/switch/state'
  command_topic: 'CBF777/switch/switch'
  optimistic: false

Schematic

  • VCC (Sonoff) -> VCC (FTDI)
  • RX (Sonoff) -> TX (FTDI)
  • TX (Sonoff) -> RX (FTDI)
  • GND (Sonoff) -> GND (FTDI)

Schematic

Versions

  • 1.0: Initial version
  • 1.1: Add TLS support
  • 1.2: Add PIR motion sensor support

THE SOFTWARE IS PROVIDED "AS IS", WITHOUT WARRANTY OF ANY KIND, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND NONINFRINGEMENT. IN NO EVENT SHALL THE AUTHORS OR COPYRIGHT HOLDERS BE LIABLE FOR ANY CLAIM, DAMAGES OR OTHER LIABILITY, WHETHER IN AN ACTION OF CONTRACT, TORT OR OTHERWISE, ARISING FROM, OUT OF OR IN CONNECTION WITH THE SOFTWARE OR THE USE OR OTHER DEALINGS IN THE SOFTWARE.