Lot's of extra travel #51
Unanswered
kizzelwhix
asked this question in
Q&A
Replies: 2 comments
-
|
Splooges seem to be at the seam. I reduced extrusion multiplier to 1, wallreorder 1, nonplanar 1. The extra trave seems to have mostly disappeared, but the splooges (and, historically, extra retraction) remain. Is it multiplying retractions/deretractions as well? |
Beta Was this translation helpful? Give feedback.
0 replies
-
|
With retraction turned off :/ |
Beta Was this translation helpful? Give feedback.
0 replies
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
-
Left screen - outputted Gcode from \bricklayersNonPlanarInfill.py" -extrusionMultiplier 1.05 -wallReorder 0 -nonPlanar 1 -amplitude 0.6 -frequency 1.1;
Right screen - Sliced model in Orca
Just for the hell of it, I tried the print. It made the first perimeter swoop, splooged a bunch of filament out, retracted some stupid amount, then continued to print nothing until I canceled it.
Beta Was this translation helpful? Give feedback.
All reactions