Different infil patterns in Prusaslicer

[Sol1tas]

Into further testing, I fond out that script is dependent on prusaslicer's profile settings such as

top infil pattern
ironing
top infil flow
top infil extrusion width (aka nozzle diameter) and probably more

The results... may vary to say the least. Some infil patterns print worse than others and some aren't recognized by script at all (archimed for example with g2-g3 commands).

Also the flow and line width more than nozzle diameter (this is simple setting to an over-extrusion for the stronger prints) obviously greatly affects endresult of the script

If so, the script needs additional checks onto those settings or at least it needs to be mentioned on the manual