MeshCental running in DigitalOcean stops running "randomely"

[apex-devteam]

Hello all. I have the MeshCental running in DigitalOcean.
I'm able to run the service and log in to it without a problem. I currently have two test PCs (win10 pc) connected. My problem so far is two issues. First, MeshCental seems to get disconnected and the service stops running at some point in time. I'm not sure what's causing this problem. The only way to resolve this issue is to SSH back in and start the MeshCental again. Second, the installed PC Agents sometimes show offline and will not connect. I check to verify the remote PC is online and the MeshAgent is running. It will connect after I stop the service and run again.

Any suggestions regarding these two issues will be greatly appreciated. Thank you.

[si458]

How did you install meshcentral to begin with?
How do u start meshcentral?
What does ur config.json look like

[apex-devteam]

Hi Simon. I should've replied sooner, but I was going through the MechCentral YouTube and the installation guide. I've solved the issues. Thank you.

[apex-devteam]

Hello.
I got my problems resolved. First issue, I set up MechCentral as a service per instructions in the Installation Guide pdf. The second problem is resolved by the agent ping and browser pong" settings as suggested by the "MeshCentral - Agent Ping and Browser Pong" Youtube.

I found MechCentral Youtube channel very helpful. Thank you.