Have the same PWM and inverted PWM on different pins for H-bridge

[a0s]

00:00:00.001 HDW: ESP8266EX
00:00:00.050 CFG: Loaded from flash at F9, Count 387
00:00:00.055 QPC: Count 1
00:00:00.071 Project tasmota - Tasmota Version 14.4.1(release-tasmota)-2_7_8(2024-12-15T13:29:54)

I need to control the full H-bridge using PWM. For this I need PWM on one pin, and the same inverted PWM on the other pin.

I setup SetOption15 0 and SetOption68 1,

then i tried this configuration:
D2 GPIO4 PWM - 1
D1 GPIO5 PWM_i - 1
and got this:

Also i tried to check does PWM_i works on different channels:
D2 GPIO4 PWM - 1
D1 GPIO5 PWM_i - 2
got this:

This non inverted PWM shows the same pictures:
D2 GPIO4 PWM - 1
D1 GPIO5 PWM - 2

Looks like inverted pwm just not working. What am i missed? Why PWM+PWM_i doesn't work as expected?

[sfromis]

Your scope images does not show anything about inverted or not, that would be visible with duty cycle 100%, where it should then be flat lines at the low and high voltages. Whether PWM pulses on independent channels are in phase is a different thing, where SetOption134 for auto-phasing is relevant for H-bridge. See
https://tasmota.github.io/docs/Peripherals/#pwm

[Jason2866]

H-bridge is not supported with esp8266