Skip to content

Latest commit

 

History

History
56 lines (31 loc) · 2.35 KB

README.md

File metadata and controls

56 lines (31 loc) · 2.35 KB
Raw

About

Avnet IoTConnect AT Command Interface project example for the Renesas EK-RA6M4.

This code is based on the CK-RA6M4 Sample Code project and uses an IoTConnect AT Command-enabled PMOD module (e.g. DA16K based) as a gateway.

quickstart_ek_ra6m4_ep Copyright 2023 Renesas Electronics Corporation and/or its affiliates.

Dependencies

The project uses the following dependent projects:

A fully set up DA16600 PMOD Module is required to be set up and connected to IoTConnect.

Follow the DA16K AT Interface Quick Start guide.

Supported Boards

Renesas EK-RA6M4 with DA16600 Wi-Fi-BLE combo module.

Getting Started

Follow the Renesas EK-RA6M4 Quick Start Guide to set up your EK-RA6M4 board for use.

Make sure the DA16x00 device is connected to the PMOD1 connector.

Follow the Quickstart Guide to flash the included binary image and use it.

Supported IoTC Device Commands

You can add these to your device template in the IoTConnect Dashboard.

  • set_red_led <state>

    Controls state of red LED on the board

    • on - Turns red LED on
    • off - Truns red LED off

  • set_led_frequency <freq>

    Controls the frequency of the blue LED flashing on the board

    • 0 - Slow blinking
    • 1 - Medium blinking
    • 2 - Fast blinking
    • 3 - Very fast blinking

Building & Development

Install the Flexible Software Package with e² Studio IDE.

The project is tested and built with FSP version 5.0.0, but it may work with later 5.x.x versions.

You can now open / import, build and debug the project as per the Renesas Quick Start guide.