EFB Configuration

Stratux Europe Edition supports two different protocols to connect to EFBs: GDL90 and FLARM-NMEA. Different EFBs have different qualities in their implementation. This page is intended to provide experiences with different EFBs and how they need to be configured to work as good as possible with Stratux Europe Edition. Other configurations are possible, this is just what experience has shown to work best. These settings apply as of 1.5b2-eu010.

SkyDemon, using FLARM-NMEA protocol

Stratux config

• SkyDemon disconnect workaround - enable
• IP Address - 192.168.1.1

SkyDemon config

• Settings / Third-Party Devices enable "FLARM with Air Connect"
• Go Flying / Use FLARM with Air Connect

SkyDemon, using GDL90 protocol

• less recommended as FLARM-NMEA has better support for bearingless targets

Stratux config

• GDL90: Use MSL instead of HAE - disable
• SkyDemon disconnect workaround - enable
• IP Address - 192.168.10.1

SkyDemon config

• Settings / Third-Party Devices: enable "GDL90 Compatible Device"
• Go Flying / Use GDL90 Compatible Device

Foreflight

• GDL90: Use MSL instead of HAE - disable
• IP Address - 192.168.10.1
• optional: GDL90 bearingless target circle emulation - enable

Flymap

Stratux config

• IP Address - 192.168.1.1

Flymap config

• Menu -> Flarm, activate Flarm

Sky-Map

• In settings, activate wireless interface
• Activate traffic warnings
• Vertical/Horizontal range as desired
• Use GPS data instedad of internal GPS enabled (recommended for correct relative altitude information)
• Wireless Interface: stratux

If you want to use AHRS:

• IP Address: udp:4000

If yo don't care about AHRS, but want a more stable traffic display:

• IP Address 192.168.10.1
• Password - anything, e.g. 1234 or 1111. Stratux does not verify the password

Airmate (only iOS version!)

Stratux Config

• GDL90: Use MSL instead of HAE - disable
• IP Address: 192.168.10.1

Airmate Config

• ADS-B Receiver: config should be automatic, Display FLARM traffic: off
• GPS Source: Stratux

VFRnav version 3

Settings -> FLAM, ADSB-IN config -> Select Stratux and enter WIFI network Pretty good Stratux support. Data is also read from Stratux Webservice, so for example CPU temperature is available in VFRnav settings.

easyVFR 3, using GDL90 protocol

Stratux config

• GDL90: Use MSL instead of HAE - disable

easyVFR 3 config

• tbd.

easyVFR 4, using GDL90 protocol

Stratux config

• GDL90: Use MSL instead of HAE - disable

easyVFR 4 config

• automatically detects and selects Stratux when connected

Garmin Pilot

not supported. Might work with the Flight Simulator (X-Plane) protocol.