Not successful to make it working #58
Replies: 4 comments 12 replies
-
In your log I see "Error bits 2" which has value https://github.com/dzurikmiroslav/esp32-evse/blob/master/components/evse/include/evse.h#L12 |
Beta Was this translation helpful? Give feedback.
-
Thank you Miroslav for prompt answer. I did everything described in wiki, (with simulator), all values are correct. After connecting car when charging is not "enabled", green diode starts to blink. But after I switched "enabled", it shows error. I have direct connection, no socket. Is there (should be) any resistor build in charging cable? Is there an option to have "disable" charging by default after restart? I don't have oscilloscope :( Please explain me what is "authorisation" and what is expected behaviour when sen to ON or OFF. |
Beta Was this translation helpful? Give feedback.
-
When Authorization is ON, you always need to click Authorize button after connecting EV to start charging process. Set in settings System / Charging available -> OFF and connect EV simulator in state A (diode + 2k72 resistor only). |
Beta Was this translation helpful? Give feedback.
-
Problem was with TL081, I have changed it and started working. But, if I chose cur_vlt, there is an error with reading current, and immediately disconnect with Error bits 1. Most probably reading much to much current. When CT is noc connected, shows 0.32A, and correct voltage reading, allowing to charge. Any chance to see current reading without charging, for example from some test circuit. CT is 2000/1 ... |
Beta Was this translation helpful? Give feedback.
-
What is authorization?
I have such errors
All meters are off in board.config. Fixed cable.
Please help.
Beta Was this translation helpful? Give feedback.
All reactions