i3status.conf

# i3status configuration file.
# see "man i3status" for documentation.

# It is important that this file is edited as UTF-8.
# The following line should contain a sharp s:
# ß
# If the above line is not correctly displayed, fix your editor first!

general {
	colors = true
	interval = 5
	#color_separator = "#000000"
}

order += "ethernet eth0"
#order += "ipv6"
order += "disk /"
#order += "run_watch DHCP"
#order += "run_watch VPN"
order += "wireless wlp2s0"
#order += "ethernet eth0"
order += "battery 0"
order += "volume master"
order += "cpu_temperature 0"
order += "load"
#order += "tztime local"
order += "time"

wireless wlp2s0 {
        format_up = " %essid %ip"
        format_down = ""
}

ethernet eth0 {
#        # if you use %speed, i3status requires root privileges
#        format_up = "E: %ip (%speed)"
	format_up = ""
#        format_down = "E: down"
	format_down = ""
}

cpu_temperature 0 {
        format = "%degrees °C"
        path = "/sys/class/thermal/thermal_zone1/temp"
}

battery 0 {
	format = "%status %percentage %remaining "
	status_chr = ""
	status_bat = ""
	status_full = ""
	#status_full = ""
}

volume master {
	format = ": %volume"
	format_muted = ": (%volume)"
	device = "default"
	mixer = "Master"
	mixer_idx = 0
	#interval = 1
}

time {
	format = " %H:%M:%S	 %d-%m-%Y"
}

#battery 0 {
#	format = "%status %percentage %remaining %emptytime"
#	format_down = "No battery"
#	status_chr = "CHR""
#	status_bat = "BAT"
#	status_full = "FULL"
#	path = "/sys/class/power_supply/BAT%d/uevent"
#	low_threshold = 10
#}

run_watch DHCP {
        pidfile = "/var/run/dhclient*.pid"
}

run_watch VPN {
        pidfile = "/var/run/vpnc/pid"
}

tztime local {
        format = "%Y-%m-%d %H:%M:%S"
}

load {
        format = "%1min"
}

disk "/" {
        format = " %avail"
}