Version 0.2.4

fixed typo for gpio power devices

Version 0.2.3

features

• power control panel on dashboard
• flip webcam image
• add slicer version in gcode file list
• add SSL support
• display SAVE_CONFIG button if there are unsafed config settings
• add PWA startscreen settings and logos
• add generic_heaters to dashboard heaters

fixed issues

• enable extrude buttons without reload mainsail
• escape filenames for delete command
• disable brower autocomplete in console
• move gui.json from gcodes to config

Version 0.2.2

Update all websocket commands for the moonraker api update

features

• change to metadata api notification
• add "edit file" button in context menu of configfiles

fixed issues

• remove M120/M121 by extrude buttons
• check websocket status before send requests
• gcode filelist content menu "print start" wrong action

Version 0.2.1

features

• show gcode thumbnails on dashboard

fixed issues

• fixed extrude buttons with & without min_extrude_temp
• print pause button -> loading reset after request
• display current z-offset value (moved in klipper)
• display issue in Settings > Machine, if klipper != ready
• show favicon if print process == 100%
• settings panel optimize responsive view
• auto expand min/max in heightmap is lower -1 or heigher 1
• sticky toolbar in config editor (toolbar & scrollbar overlap)

Version 0.2.0

Update all functions to Moonraker version from 'August 16 2020'

features

• add new logo
• show version number in footer
• reprint job button after print
• show stats after print

fixed issues

• toolSlider extend only by machine limits
• performance load from temp chart

Version 0.1.3

Update all functions to Moonraker V0.1. This is only a temporary version because the Klipper webhooks are not final.

features

• add config editor

fixed issues

• enable extruder buttons without min_extrude_temp in config file
• machine limits auto extend
• fixed filament runout sensor switch

Version 0.1.2

fixed issues

• switch to klippy !is_ready fixed
• disable heater with value 0
• add timestamp to gui.json for caching problems
• remove "move=1" before homing on the babystepping buttons

Version 0.1.1

new features

• add Z_TILT in ControlPanel
• add 0.01mm babystep buttons

fixed issues

• update notifiy_filelist_changed websocket message
• rename "Host Restart" to "Host Reboot"

Version 0.1.0

new features

• update to Moonraker .08-alpha
• show temperature_probe in ToolPanel + Tempchart
• finish bed_mesh control & visualisation
• babystepping on dashboard (only during a print)
• gcode files -> manage directories, manage files, show gcode thumbnails (PrusaSlicer & SuperSlicer only)
• warning & block too high or too low temps in tool panel
• print stats -> convert filament used greater then 1000mm to m

fixed issues

• sort heaters & temp sensors in the tempchart
• virtual_sdcard.progress not loaded at startup
• firmware restart reset the storage
• and many little bugs...

Version 0.0.12

fixed issues

• time format in status panel