[Bug]: T114 GPS won't update #5624
Replies: 8 comments 22 replies
-
Hi, could you define "won't update" in a bit more detail? Also, is it possible to provide log files, such as those from the serial console at flasher.meshtastic.org |
Beta Was this translation helpful? Give feedback.
-
I am so sorry. I mean the GPS position won't get update from T114 v2. It will only show the position when it get the signal then no update at all. |
Beta Was this translation helpful? Give feedback.
-
No need to apologize :) Also, thank you for testing the latest firmware, we appreciate your support :) I have a T114, so I will try to confirm the problem. To be clear, is this what happens:
|
Beta Was this translation helpful? Give feedback.
-
Beta Was this translation helpful? Give feedback.
-
i continued testing all day, and have a position packets consistently throughout. I have ended the test as i have not experienced any issues (even when having the node sitting at home for a few hours with smart position enabled i got a few stationary updates). |
Beta Was this translation helpful? Give feedback.
-
pls advise i try to use heltec t114 rev 2 with gps l76k but no connection to the gps does any one can help with simple code that read the gps and put the data n serial port |
Beta Was this translation helpful? Give feedback.
-
Finally I was able to find the issue and fixed the Heltec T114 v2 GPS no update. It is related to the iOS and Android channel setting. iPhone is my main device. I have a Android phone but never use it for the Meshtastic. Someone mentioned "imprecise location" in the channel setting on Reddit. So I go over the iOS app and not able to find it in "LongFast" default channel. But on the Android app, there is "Precise location" and it is off. After I turn it on the GPS start to update as Hecltec V3. I think it is bug for the iOS app without having this setting. App version used:
Solution:
|
Beta Was this translation helpful? Give feedback.
-
Congratulations on finding the issue. Thank you for your patience and sharing your findings. |
Beta Was this translation helpful? Give feedback.
-
Category
Other
Hardware
Heltec Mesh Node T114
Firmware Version
2.5.15
Description
I have Heltec V3 and T114 v2. With same setting the V3 will update without issue for the route. But the T114 only update once it get the signal and no update at all. BTW, I tried all the versions early than 2.5.15 as well.
Relevant log output
No response
Beta Was this translation helpful? Give feedback.
All reactions