Modbus Winet-S Wifi and LAN

[Mats1717]

Hi
I need the modbus port for other things so I tried over Winet-S both Wifi and LAN.
It isent realy much that will not work on that way. I will upload 2 files. One working with out any faults in the log and one what is removed.
Not working
Some long term statistics (removed)
backup_phase_power (removed)
Inverter state (not removed but not working in dashboard, maybe can be fixed by somebody)
Grid frequency (fixed had to rescale it, was showing 500 instead of 50)

My skills stop here but maybe it could be a light version for them that can not use regualar modbus port.
I dont have a battery yet so a can not say if there is som scaling issuses
My inverter is SH8.ORT
modbus.sungrow_working_Winet-S.txt
Removed_from_modbus_Sungrow.txt

Regards Mats

[Louisbertelsmann]

You can set up a modbus proxy on homeassistant. Then the other application uses homeassistant as the modbus source.

[Mats1717]

The other device is creates a new subnet and sets the IP adress to the Sungrow port by DHCP så I dont think it will be a good solution

[Louisbertelsmann]

if you can change the IP on the other device, it doesn't remove any functionality.

[Mats1717]

Its not possible. Think I solved the issue with running state in my file. Will test tomorrow when inverter goes from standby.
If so i will be fine with running on Winet port. Will edit file above if it works

[Mats1717]

My way was not the right way to fix the issue. Hope that someone else has the knowledge to fix it.
If not I have to be fine with the sensors that is working.