flash

#!/bin/sh -e

setProgramMode() {
  # Control Pins to put JN516x in bootloader mode
  # Pin ZIGBEE_PROGRAM - CSID6 -  PE10 (4*32 + 10) = 138
  # Pin ZiGBEE_RESET - CSID7 - PE11 (4*32 + 11) = 139
  echo "Set up program mode for zigbee module"
  if [ ! -d /sys/class/gpio/gpio138 ]; then echo 138 > /sys/class/gpio/export; fi
  if [ ! -d /sys/class/gpio/gpio139 ]; then echo 139 > /sys/class/gpio/export; fi

  echo "out" > /sys/class/gpio/gpio138/direction
  echo "out" > /sys/class/gpio/gpio139/direction

  echo 0 > /sys/class/gpio/gpio138/active_low
  echo 1 > /sys/class/gpio/gpio139/active_low

  #resetLow
  resetHigh
  programHigh
  programLow
  resetLow
}

programLow() {
  if [ -z "$1" ]; then TIMEOUT=1; else TIMEOUT=$1; fi
  echo "Program 0"
  echo 0 > /sys/class/gpio/gpio138/value
  sleep $TIMEOUT
}

programHigh() {
  if [ -z "$1" ]; then TIMEOUT=1; else TIMEOUT=$1; fi
  echo "Program 1"
  echo 1 > /sys/class/gpio/gpio138/value
  sleep $TIMEOUT
}

resetLow() {
  if [ -z "$1" ]; then TIMEOUT=1; else TIMEOUT=$1; fi
  echo "Reset 0"
  echo 0 > /sys/class/gpio/gpio139/value
  sleep $TIMEOUT
}

resetHigh() {
  if [ -z "$1" ]; then TIMEOUT=1; else TIMEOUT=$1; fi
  echo "Reset 1"
  echo 1 > /sys/class/gpio/gpio139/value
  sleep $TIMEOUT
}

startFlash() {
  if [ $1 ]; then
    echo "Start flashing $1 on /dev/ttyS0"
    #/usr/bin/JennicModuleProgrammer -I 38400 -P 38400 -s /dev/ttyS0 -f $1 -v -V 3
    /usr/bin/iot_jp -I 38400 -P 38400 -s /dev/ttyS0 -f $1 -v -V 3
    #/usr/bin/iot_jp -I 115200 -P 115200 -s /dev/ttyS0 -f $1 -v -V 3
    result=$?
  else
    echo "Error: no firmware file passed"
  fi
}

setNormalMode() {
  # Control Pins to put JN516x in normal mode
  echo "Set up normal mode"
#  programLow 0.5
#  resetHigh
#  resetLow
}

cleanup() {
  echo "Clean up"
  echo 138 > /sys/class/gpio/unexport
 # echo 139 > /sys/class/gpio/unexport
}

setProgramMode
startFlash $1
setNormalMode
cleanup

echo "Done"