Replies: 5 comments 1 reply
-
Sorry, I have only 24v model. What voltages are you talking about? |
Beta Was this translation helpful? Give feedback.
-
For now it were tested only on 2.4kW/24v model. I added a manuals section because during my research, I accumulated various manuals. I assumed that the 1.5, 2.0, 2.4, and 3.2 models are similar because they have mostly similar manuals. I apologize for any confusion. |
Beta Was this translation helpful? Give feedback.
-
Have you tried to make a switch instead of the sensor for writing Modbus value instead of just reading it? This could be useful for remote voltage control, power source selection, ... |
Beta Was this translation helpful? Give feedback.
-
There are separate registers for reading and writing. I am using the modbus_select component for changing write registers. For binary values, you can use the Modbus Switch component instead. So, in principle, you can use modbus_switch to change the values of write registers from the list. |
Beta Was this translation helpful? Give feedback.
-
Hi, I have a 10.2kw unit and am trying to change the threshold voltage for back to utility and back to battery (registers 5025 and 5026) but can't figure out the mapping (if any) of the voltages and value to pass on to the register. any idea/suggestion of things to try? Thanks |
Beta Was this translation helpful? Give feedback.
-
I have POW-HVM1.5H-12V, will it be possible to control the voltages?
In the smartess application, it is not possible to control the voltages for 12v. There is only a choice of 24v or 48v.
Has anyone tested this integration with a 12v inverter?
Beta Was this translation helpful? Give feedback.
All reactions