Home

• General Hardware Information

• Basic functions - binding, failsafe, etc.

• Connecting hardware to a computer

• How to flash (software updates)

• How to configure settings, and information on settings

• Guide to using the Telemetry features (2-way radio)

• Using LBEEP (link loss beep over FPV audio)

• Using two RX:s for diversity (EXPERIMENTAL)

• Using receivers as transmitters

• Feature comparison of supported hardware

Important Warnings!!!

The radio modules on all 100mW models are not 5 volt tolerant. If you connect 5 volt power to the programming headers, you may damage the radio module. Only connect a programming cable that provides 3.3 volt power. Fortunately, the other components on the receivers and transmitters are tolerant of 5 volts, and the radio module is replaceable if you damage it.

Always attach an antenna.

Never power on any receiver or transmitter for any reason without a suitable antenna attached. This includes when you are connecting it to a computer for software updates. All receivers are also capable of transmitting.