You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I developer rails apps along with PHP websites. When I have POW installed on OSX 10.10 the rails apps load fine, but I cannot get the PHP websites to load with my virtual host and /etc/hosts file configuration. When I uninstall POW my PHP apps start up again.
Is there a configuration issue with POW / Powder that is not fully disabling POW when I run powder down?
Thanks
The text was updated successfully, but these errors were encountered:
Hi @rodreegez I wasn't able to run PHP at all when POW was running. I ended up using the following link and I can run both systems at the same time now.
@cwseric Pow redirects all incoming traffic on port 80 to port 20559, where Pow runs. This means e.g. that Apache will be inaccessible without either disabling the firewall rule or updating that server's configuration to listen on another port. (See http://pow.cx/manual.html#section_1)
I created this Gist to completely disable pow and all firewall rules on MacOSX Yosemite, in order to get access to my local webserver (Apache) on port 80.
Hello,
I developer rails apps along with PHP websites. When I have POW installed on OSX 10.10 the rails apps load fine, but I cannot get the PHP websites to load with my virtual host and /etc/hosts file configuration. When I uninstall POW my PHP apps start up again.
Is there a configuration issue with POW / Powder that is not fully disabling POW when I run powder down?
Thanks
The text was updated successfully, but these errors were encountered: