You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I am having a problem where the mmu2s unit is booting up in stealth mode and not in normal mode. For some reason i get a hardware fault (all 10 leds flashing) in stealth mode. The only way to fix this is to swap modes in the printer. The unit works fine in normal mode only. Both my MK3S and the mmu2s are running the latest firmware.
The text was updated successfully, but these errors were encountered:
mmu2s V1.0.6 boots to normal mode and printer sets it to stealth mode (because its set in the printer that way)
of course you have to switch it in the printer config if you need the normal mode.
you can also reset the mmu2 after the printer booted and resetted the mmu2, then it is again in the normal mode
problem description you can find there: #167
I am having a problem where the mmu2s unit is booting up in stealth mode and not in normal mode. For some reason i get a hardware fault (all 10 leds flashing) in stealth mode. The only way to fix this is to swap modes in the printer. The unit works fine in normal mode only. Both my MK3S and the mmu2s are running the latest firmware.
The text was updated successfully, but these errors were encountered: