Infill Tools

[antwal]

Hi all,

the documentation in the wiki is very scarce and I would like to understand how the infill tool works as if I apply it, absolutely nothing changes.

Thanks.

[sn4k3]

If you used to FDM it work the same way. The model must be solid, if is hollow nothing will happen.
Then it will infill the body within a margin from walls (Configurable)
The density of infill is also configurable.
Use only on large models

[antwal]

ok i found it is a settings problem

only thing I noticed but it is another argument, by adding the supports these are also added on layer 1 where in my case there should be nothing; that is, the supports do not remain inside the object

I'll add the screen and if needed, I open an issue:

[sn4k3]

I didn't understand the last message, you can explain?

[antwal]

after adding the infill I also had to add 3 supports via the pixel editor to correct some islands that did not hook to the generated infill structure. However, these supports do not remain inside the object but have been added starting from layer 1

[sn4k3]

I still can't get it. I need a set of images or video if possible of the problem

[antwal]

ok i can prepare a video, no problems