Printer first lay stops at first layer. #657
-
Hello, So I am using UVtools to convert formats and check for issues, however everytime I start a print the printer moves to the first layer exposure position and them stops, the lcd touchscreen becomes unresponsive. It basically freezes and the first layer and does not continue the print. I am converting from chitubox to Vlare open format (.osf). |
Beta Was this translation helpful? Give feedback.
Replies: 3 comments 31 replies
-
Which printer are you using? |
Beta Was this translation helpful? Give feedback.
-
Glad you posted this. I was pulling my hair trying to figure out what was wrong. I'm experiencing the same issue you've described and thought it was Lychee Slicer. |
Beta Was this translation helpful? Give feedback.
-
Hello, I am encountering the same issue using UVTools to detect and repair issues in files for my Phenom Forge. Vlare and Lychee osf exports print fine straight from the slicer. They will also print fine if they are run through UVTools and are saved straight out with no alterations. I have attached 3 osf files, all from the same slice from VLare. "Gear_Original" is straight out of Vlare, (Gear_UVTools_Copy) is saved out of UVTools with no alterations, and Gear_Original_Copy_(REPAIRED) is a version where I used the brush to create an error and then detected and repaired it, (this is the one that will not print). |
Beta Was this translation helpful? Give feedback.
ok, found the problem. Will be on next patch.