What am I missing??? #983
-
|
I can't seem to get any readings in the control panel. Per the comms tab I am getting 100% success rate of bytes sent however nothing is showing in the panel. I have a new WhisperFlo VST Pentair pump with the data cable hardwired to a RS485 usb receiver in a windows PC. On the display of the physical pump when I turn on the service it says AUTO on the pump so its clearly knows its hooked to something. When I put the software into service mode all functions are then working on the pump. See screenshots:
What am I missing? Thanks. |
Beta Was this translation helpful? Give feedback.
Replies: 3 comments 1 reply
-
|
Under the Config->Pumps tab you need to add circuits for the speeds. You should start with the Pool circuit and then can add more for different speeds. |
Beta Was this translation helpful? Give feedback.
-
|
Yeah, I had already had those set up, but still nothing. I would think it would also show that the pump is on or something to that effect. |
Beta Was this translation helpful? Give feedback.
-
|
Pump Speed +/- are specific for spa side remotes. You'll need to setup a new aux circuit for the FASTER speed and set the Pool circuit to be the slower speed. |
Beta Was this translation helpful? Give feedback.
-
|
That worked, thank you. |
Beta Was this translation helpful? Give feedback.
Pump Speed +/- are specific for spa side remotes. You'll need to setup a new aux circuit for the FASTER speed and set the Pool circuit to be the slower speed.