Small Triangle Panels (<0.001 mm) Not Highlighting in Mesh Check

[AadarshGejage]

Dear Support Team,
During analysis, I receive an error message stating that there are panels with element width less than 0.001 mm.

Previously, when using the "Check Mesh" option, such small or problematic panels were highlighted in blue color.

However, currently when I run "Check Mesh", no panels are being highlighted, even though the error message still reports that two elements are smaller than 0.001 mm.

The message log indicates specific element numbers, but visually I am unable to locate or identify them in the 3D view.

The issue appears to be in the fuselage region.

My questions are:

Why are these very small triangle panels not being highlighted in the mesh check window?

Is there a tolerance threshold below which panels are not visually marked?

Could this be related to numerical precision or display limitations?

Is there a way to directly select or isolate the reported element numbers in the 3D view?

Are there recommended mesh or geometry settings to prevent creation of such microscopic panels?

[techwinder]

The option "Center view on Panel" should help.

[AadarshGejage]

thank you it works to show panel, but their still small edges are created that won't show in when I am importing the cad