Tailscale fails to start after install

[yodaphone]

Ran the Tailscale script and it asks the question have you replaced it with your LXC ID & i say Y. the script says " Installing Tailscale...
" and immediately ends. No additional messages etc.

The LXC is created on PVE but when i try to start it, i get this error

TASK ERROR: missing 'arch' - internal error at /usr/share/perl5/PVE/LXC.pm line 607.

[tteck]

This script will add Tailscale to an existing LXC Container ONLY

[buczi11]

What node are you adding Tailscale to?

[yodaphone]

Never mind. I was under the assumption that it will create the LXC and install. It worked when I ran it after I created the LXC

[mrtrofimov]

Hi guys! I got stuck with an installation problem. I have a newly created LXC container that I created with a debian 11 template. When I run the script, script says "Installing Tailscale..." and immediately ends. No additional messages etc. Tell me what I'm doing wrong. Sorry I'm new to this.

[mrtrofimov]

If I only could guess what the problem is. I tried to do the same with LXC Ubuntu with the same result. What kind of a diagnostic information could help?

[JuanGrados]

@mrtrofimov did you succeed? I have the same problem, I tried with two different LXC, a Debian based and Ubuntu based.
Then running the script from the shell of the PEV and nothing, it just exits after "Installing Tailscale...".
If I try to run tailscale up from the LXC it says command not found...

[tteck]

Just checked again

  ______      _ __                __        
 /_  __/___ _(_) /_____________ _/ /__      
  / / / __ `/ / / ___/ ___/ __ `/ / _ \     
 / / / /_/ / / (__  ) /__/ /_/ / /  __/     
/_/  \__,_/_/_/____/\___/\__,_/_/\___/      
                                            
This will add Tailscale to an existing LXC Container ONLY. Proceed(y/n)?y
Installing Tailscale...
Installed Tailscale
 ✔ Completed Successfully!
 Reboot 111 LXC to apply the changes, then run tailscale up in the LXC console
root@server:~# 

Are you using SSH?

[JuanGrados]

Thanks for checking.
No, I am not running via ssh, I am doing it from the web interface of Proxmox.
However, after restarting the server it is running just fine.

Thanks again.
cheers

[samsong]

if anyone else has this problem:

• I had installed debian 12 standard via proxmox template. same issue "command not found" & the installer finished without any message.

• deleted the container. created again using ttecks own lxc ubuntu script. version 24.

• then run the command again and it works. must be a problem with the debian lxc i created. not sure why