RISC-V Simualtor

Team Details

Paras Goyal	2018CSB1111
Ekansh Mahendru	2018CSB1087
Hansin Ahuja	2018CSB1094
Sakshay Mahna	2018CSB1119
Atul Tiwari	2018CSB1077

Instruction Formats

R-Type:
	ins rd rs1 rs2
I-Type (Except jalr ):
	ins rd rs1 immed
SB-Type:
	ins rs1 rs2 label
S-Type:
	ins rs1 immed(rs2)
U-Type:
	ins rs1 immed
UJ-Type:
	jal rd label
jalr:
	jalr rd immed(rs1)

Note : jalr is different from I Type as we had followed the version similar to https://www.kvakil.me/venus

Note : We recommend cloning the source directly from https://github.com/Ekan5h/RISC-V-ISA-Simulator directly to set it up.

Instructions to setup GUI for Phase 3 (incorporates Phase 2 as well)

1. Extract RISCVSim.tar.gz
2. Run the install script
3. Run the Risc-V simulator from the shortcut.

Note: This install script is specific to Linux. For more details please refer to requirements.txt

Instructions to Use CLI

1. Navigate to the directory containing the Makefile.
2. Run the following command for executing the Phase 2 code (without Piplining): make p2 INP=path/to/the/file(without the asm extension)
3. Run the following command for executing the Phase 3 Code (with Piplining): make p3 INP=path/to/file (without the asm extension)

Example:
make p2 INP=test

Example 2:
make p3 INP=bubble

Example 3:
make p3 INP=fib

Note: File needs to be in same directory as the Makefile

Contributions

As this was a team project so it is difficult to completely segregate out the work done by each us but the following would give some outline.
Sakshay - I Type
Atul - S Type
Hansin - SB Type
Paras - R UJ Type
Ekansh- U and GUI

Note- It was not strictly followed, and we helped each other in both the phases.