SCV.py:

modifies SCV based on the angle in a turn of the outer wall. To adjust the SCV values, modify the dictionary scv_by_angle and adjust the ranges in quantize_angle.

near_top_wall_accel.py

slows down wall accel near top surfaces:

you need to pass it a config file like this:

[Acceleration]
near_top_surface_accel = 500
default_accel = 3000
layers_below_top = 2

fast_curves.py

speeds up accels and SCV on the curves of prints

you need a config file called curve_speed_config.cfg with this in it:

[CurveBoost]
high_accel = 4000
high_scv = 10.0
angle_threshold_deg = 5
min_segment_length = 0.5
min_curve_length = 3