Multirate Chatter Analysis is an analysis of chatter vibration.
To use this, just type in MATLAB
run_MCA
Then you will get these results:
Stability Lobe Diagram.
Singular-Value Map With Stability Lobe Diagram.
You can change some parameters shown below for your analysis.
In data/make_Global.m, you can edit
AE %Radial depth of cut (m)
D %diameter of tool (m)
FLUTES % number of teeth
UP_OR_DOWN %UP(1) or DOWN(-1) MILLING
W_ST % starting depth of cut (m)
W_FI % final depth of cut (m)
O_ST %starting spindle speed (rad/s)
O_FI %final spindle speed (rad/s)
TAU_NORM %nominal period \tau for SLD (s)
.
In data/make_SDM.m, you can edit
SDM.stx % steps of spindle speed
SDM.sty % steps of depth of cut
SDM.k %tau = k dt
.
In data/make_Tool.m, you can edit
Tool.plant %Tool plant system (should be 2 input (Fx, Fy) 2 output (x, y))
.
In data/make_Work, you can edit
Work.Kt %Cutting Force Coefficient in the tangential direction
Work.Kn %Cutting Force Coefficient in the normal direction
.
2018-, Shimoda Takaki, The University of Tokyo
MultirateChatterAnalysis is free software; you can redistribute it and/or modify it under the terms of the GNU General Public License as published by the Free Software Foundation; either version 3 of the License, or (at your option) any later version.
MultirateChatterAnalysis is distributed in the hope that it will be useful, but WITHOUT ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the GNU General Public License for more details.