Releases: NicoAICP/PTPE
Releases · NicoAICP/PTPE
Emulation Testing
You have to Build the Board like the Instructions tell you too, or use your board from Hardware Test.
Boot up PTPE with an SD card inserted.
Afterwards, shut PTPE down by unplugging.
Now put the SD Card into your Computer and put any Skylander File in .bin format into the Skylander Folder (ONLY ONE)
If you now boot up PTPE, Select Skylanders and then hit Add Skylander, it will Emulate that single Skylander.
This was tested to work on following Devices:
- Raspberry Pi Pico (RP2040)
- Raspberry Pi Pico W (RP2040)
- Raspberry Pi Pico 2 (RP2350)
Hardware Test
THIS WILL NOT EMULATE ANY SKYLANDERS, DISNEY INFINTIY FIGURES OR LEGO DIMENSION FIGURES YET
This is just a .uf2 file to check if you hardware will even run PTPE.