Add Limelight 3G

.github/workflows/main.yml

@@ -20,6 +20,9 @@ jobs:
             base_image: https://downloads.raspberrypi.com/raspios_lite_arm64/images/raspios_lite_arm64-2024-07-04/2024-07-04-raspios-bookworm-arm64-lite.img.xz
           - name: limelight3
             script: ./install_limelight3.sh
+            base_image: https://downloads.raspberrypi.com/raspios_lite_arm64/images/raspios_lite_arm64-2023-12-11/2023-12-11-raspios-bookworm-arm64-lite.img.xz
+          - name: limelight3g
+            script: ./install_limelight3g.sh
             base_image: https://downloads.raspberrypi.com/raspios_lite_arm64/images/raspios_lite_arm64-2024-07-04/2024-07-04-raspios-bookworm-arm64-lite.img.xz
           - name: raspi
             script: ./install_pi.sh

install_limelight3g.sh

@@ -0,0 +1,7 @@
+# Run the pi install script
+./install_pi.sh
+
+install -m 644 limelight3g/config.txt /boot/
+
+# Add the one extra file for the LL3
+wget https://datasheets.raspberrypi.org/cmio/dt-blob-cam1.bin -O /boot/dt-blob.bin

limelight3g/config.txt

@@ -0,0 +1,57 @@
+#uncomment to overclock the arm. 700 MHz is the default.
+#arm_freq=800
+
+# Enable audio (loads snd_bcm2835)
+dtparam=audio=on
+
+[cm3]
+dtparam=cam0_reg
+dtparam=cam0_reg_gpio=3
+dtoverlay=cm-swap-i2c0
+dtoverlay=ov9281,cam0
+
+# Automatically load overlays for detected cameras
+camera_auto_detect=1
+
+[cm4]
+dtoverlay=ov9281
+
+[all]
+
+# Automatically load overlays for detected DSI displays
+display_auto_detect=1
+
+# Enable DRM VC4 V3D driver
+dtoverlay=vc4-kms-v3d
+dtparam=spi=on
+dtparam=audio=off
+
+max_framebuffers=2
+
+# Run in 64-bit mode
+arm_64bit=1
+
+# Disable compensation for displays with overscan
+disable_overscan=1
+
+[cm4]
+# Enable host mode on the 2711 built-in XHCI USB controller.
+# This line should be removed if the legacy DWC2 controller is required
+# (e.g. for USB device mode) or if USB support is not required.
+otg_mode=1
+
+[pi4]
+# Run as fast as firmware / board allows
+arm_boost=1
+
+[all]
+#camera_auto_detect=1
+gpu_mem=256
+
+[cm3]
+dtoverlay=enc28j60
+dtoverlay=pi3-disable-bt
+gpio=45=op,dh
+disable_camera_led=1
+disable_splash=1
+force_eeprom_read=0