GRPRP

Golden Rose's Paper Re-pulper Prototype

Rust project for the Arduino Uno.

Build Instructions

1. Install prerequisites as described in the avr-hal README (avr-gcc, avr-libc, avrdude, ravedude).

2. Run cargo build to build the firmware.

3. Run cargo run to flash the firmware to a connected board. If ravedude fails to detect your board, check its documentation at https://crates.io/crates/ravedude.

4. ravedude will open a console session after flashing where you can interact with the UART console of your board.

License

Licensed under either of

• Apache License, Version 2.0 (LICENSE-APACHE or http://www.apache.org/licenses/LICENSE-2.0)
• MIT license (LICENSE-MIT or http://opensource.org/licenses/MIT)

at your option.

Contribution

Unless you explicitly state otherwise, any contribution intentionally submitted for inclusion in the work by you, as defined in the Apache-2.0 license, shall be dual licensed as above, without any additional terms or conditions.