Pixmob EEPROM Flasher + Firmware

Pixmob EEPROM flasher

Instructions:

Make sure you have the .NET 8 Runtime installed
https://dotnet.microsoft.com/en-us/download/dotnet/thank-you/runtime-8.0.5-windows-x64-installer

Please make sure the Raspbery Pi Pico is flashed with the correct firmware
pixmob-eeprom-cli.uf2

Connect the pins to the Pico. Observe Diagram (raspberry-pi-pico-pin-con-guide.png)

Powering the bracelet:
VCC (+) Should be connected to a 5.3v power supply
GND (-) Also should be connected to the same 5.3v power supply

Alternatively you can also connect the VCC to the Pico's 3.3V pin if you don't want to use an external power supply. I don't recommend it however but it still does work.

You can then connect to the PICO's COM Port which will appear in the com port list in the application.