- / GET -> Control GUI
- /rest/config GET -> REST Controller config GUI
- /rest/identity
- GET -> REST Server identity
- /rest/led
- GET -> REST LED Status
- /rest/led
- POST -> REST LED Command
- /rest/pwm
- POST -> REST set PWM Settings
- /rest/fw_access
- POST -> REST set Firmware access informations
- /rest/api_access
- POST -> REST set api access informations
- /rest/wlan_access
- POST -> REAT set WLAN SSID,PASSWD,mDNS Hostname
Factory RESET GPIO34 (defined in ProjectDefaults.hpp "RESET_SWITCH_PIN") to ground while start controller.
Than controller spans an WLAN as Accesspoint with addr 192.168.4.1 and SSID "LED-AP-XXXXXX" while XXXX is the internal chip number. The password is "password". Not supriseing...
If you connectet with the controller, you may give an URL, it's equal. The internal DNS Micro Server resolve the Controlers IP and you will connected to the main Site. There cou my config some things.
Or you can put the controller in your WLAN over Url http://192.168.4.1/ (then click in "config controller") or http://192.168.4.1/rest/config
the initial account is admin, password admin
You can config the PWM resolution (8, 10, 12 or 15 bits), the frequency in range 400 Hz up to 50 kHz. You can also (for example for one anode RGB LED) invert the PWM signal. This propertys ar availible in the config page. You can also set the account for config, and if you whish an account for using the API.
All the Propertys are stored in teh NVM of the Controller.
enjoy!