Marlon Mark I - 3D Printer

Introduction

Marlon is a Marlin firmware based 3D Printer. It uses RepRap concept with RAMPS.

Cloning

git clone --recurse-submodules https://github.com/marcio-pessoa/Marlon.git

Changes

All notable changes to this project will be documented in this Change log.

Mechanics

This project uses an original mech made from scratch with the following goals:

• Reliable
• Precise
• Robust
• Well done
• Almost cheap, but very beautiful

Check out Mechanics design to know more.

Electronics

Arduino, RAMPS and Full Graphic Smart Controller are used to Electronics control system.

Firmware

Marlin is my Firmware! :-)

Software

A lot of softwares can be used to draw 3D objects, slice, convert to G-code and print. Here are some recommended softwares.

BOM - Bill of materials

If you want to build your own, take a look at Bill of materials.

---