Python Code to control Edilkamin pellet stuve (Tiny)
This Python code runs on a raspberry pi with SPI enabled.
It uses the CYRF6936 Chip which seems obsolete :(
I have used this kind of board with some modifications for SPI... "CC2500 NRF24L01 A7105 CYRF6936 4 In 1 RF Module"
The code has been modified to work through node-red with a deamon block to rx/tx data through stdin/out
There are some unknown parameters still, example is the temperature is not decoded...
However i will use the oven in manual mode, and i can parse the 5 levels of power and i can controll all the buttons.
To-Do is to turn on/off the owen.