Skip to content

Rotorflight Configurator Release 2.1.0

Latest
Latest
Compare
Choose a tag to compare
@github-actions github-actions released this 09 Jan 09:53
· 136 commits to master since this release
release/2.1.0
2c151ea

This is the the Official Release of the Rotorflight 2.1.0 Configurator.

NOTE The firmware for RF 2.1 uses version number 4.4.x.

Downloads

The download locations are:

Notes

  • Rotorflight setup instructions can be found on the RF website www.rotorflight.org.

  • RF 2.1 is backward compatible with RF 2.0. You can load your configuration dump from RF 2.0 into 2.1.

  • If updating from RF1, please setup your helicopter from scratch. Follow the instructions on the website!

  • As always, please double check your configuration on the bench before flying!

Support

The main source of Rotorflight information and instructions is now the website.

Rotorflight has a strong presence on the Discord platform - you can join us here.
Discord is the primary location for support, questions and discussions. The developers are all active there,
and so are the manufacturers of RF Flight Controllers. Many pro pilots are also there.
This is a great place to ask for advice or discuss any complicated problems or even new ideas.

There is also a Rotorflight Facebook Group for hanging out with other Rotorflight pilots.

Changes from 2.0.0

  • Custom CRSF/ELRS telemetry support
  • Add FrSky FBUS and F.Port2 receiver protocols
  • Add Futaba SBUS2 supprot
  • Add SBUS Output support
  • Add new SmartPort sensors
  • Automatic board detection in Firmware Flasher
  • Cyclic Cross-Coupling refactored
  • Add ACC trim adjustments
  • Add ESC log options to Blackbox
  • Add support for UART Tx/Rx Pinswap
  • Add ESC telemetry half-duplex and pin-swap toggles
  • Add support for Graupner and FlyRotor ESC telemetry
  • Improved ctrl-mouse zoom
  • Improved sidebar style
  • Refactor bottom status bar
  • Display final gear ratio
  • Hide Rates acceleration and response (until fixed)
  • Disable motor override when leaving the Motors tab
  • Display final gear ratio with decimals
  • Update slider implementation (nouislider)
  • Update Reference design port allocations
  • Update Bell 206 3D model with RF brand
  • Update RPM filter Q range to 1.5-10.0
  • Update default rates to match firmware
  • Remove gyro chip orientation fields
  • Fix many spelling mistakes
  • Add various tooltips
  • Stay backwards compatible with RF 2.0
Assets 8
Loading