Add blinky example for STM32F1 bluepill board

examples/stm32f1_bluepill_blinky/.cargo/config.toml

@@ -0,0 +1,40 @@
+[target.thumbv7m-none-eabi]
+# uncomment this to make `cargo run` execute programs on QEMU
+# runner = "qemu-system-arm -cpu cortex-m3 -machine lm3s6965evb -nographic -semihosting-config enable=on,target=native -kernel"
+
+[target.'cfg(all(target_arch = "arm", target_os = "none"))']
+# uncomment ONE of these three option to make `cargo run` start a GDB session
+# which option to pick depends on your system
+# runner = "arm-none-eabi-gdb -q -x openocd.gdb"
+# runner = "gdb-multiarch -q -x openocd.gdb"
+# runner = "gdb -q -x openocd.gdb"
+
+rustflags = [
+  # This is needed if your flash or ram addresses are not aligned to 0x10000 in memory.x
+  # See https://github.com/rust-embedded/cortex-m-quickstart/pull/95
+  "-C", "link-arg=--nmagic",
+
+  # LLD (shipped with the Rust toolchain) is used as the default linker
+  "-C", "link-arg=-Tlink.x",
+
+  # if you run into problems with LLD switch to the GNU linker by commenting out
+  # this line
+  # "-C", "linker=arm-none-eabi-ld",
+
+  # if you need to link to pre-compiled C libraries provided by a C toolchain
+  # use GCC as the linker by commenting out both lines above and then
+  # uncommenting the three lines below
+  # "-C", "linker=arm-none-eabi-gcc",
+  # "-C", "link-arg=-Wl,-Tlink.x",
+  # "-C", "link-arg=-nostartfiles",
+]
+
+[build]
+# Pick ONE of these compilation targets
+# target = "thumbv6m-none-eabi"        # Cortex-M0 and Cortex-M0+
+target = "thumbv7m-none-eabi"        # Cortex-M3
+# target = "thumbv7em-none-eabi"       # Cortex-M4 and Cortex-M7 (no FPU)
+# target = "thumbv7em-none-eabihf"     # Cortex-M4F and Cortex-M7F (with FPU)
+# target = "thumbv8m.base-none-eabi"   # Cortex-M23
+# target = "thumbv8m.main-none-eabi"   # Cortex-M33 (no FPU)
+# target = "thumbv8m.main-none-eabihf" # Cortex-M33 (with FPU)