Update Industrial Sewing Maching.md

docs/members/Equipment/Crafts/Industrial Sewing Maching.md

@@ -7,11 +7,22 @@ tags:
 ---
 # Consew 230 Industrial Sewing Machine
 
+## Manuals 
+
+## Costs and Consumables 
+### Shop Provided
+### User Provided
+
+## Functions
+
+### Specifications
+
+## Usage
 This is the green industrial table mounted sewing machine located in the craft room.  It should be plugged into the far  wall from the doorway.  The switch for the motor is on the right hand side under the table.  There will be a audibly noticeable hum if the motor is plugged in and is turned on.
 
 ![ ](/members/Equipment/images/230IndustrialMachine/230machine.jpg)
 
-## Winding the Bobbin
+### Winding the Bobbin
 This machine has a separate bobbin winding mechanism to the right of the machine that is threaded differently from threading the machine.  The thread stand has a place for two cones so if you have a second cone of the color you are using, you can leave the machine threaded and thread the bobbin winder with the other one.  Otherwise, you will have to remove the thread from the machine, and wind the bobbin first, then re-thread the machine.
 ![Threading the winder](/members/Equipment/images/230IndustrialMachine/230machine_bobbin_3.jpg)
 
@@ -27,12 +38,18 @@ Once the bobbin carrier is out, remove the bobbin. On the bobbin winder, there i
 Once the lever is open, slide the bobbin onto the spindle and pass the thread through one of the holes in the bobbin.  Close the lever again. Pressing the pedal will now wind the bobbin, hold the thread for a few rotations.
 ![Winding the bobbin](/members/Equipment/images/230IndustrialMachine/230machine_bobbin_7.jpg)
 
-## Threading the machine
+### Threading the machine
 You can use a separate cone for the machine than the bobbin, but if you only have one, remove the thread from the bobbin threading. Instead bring the thread over to the top of the machine and follow the picture sequence below to properly thread the machine
 ![Down, through the plate, around the tension plates, and out the front plate](/members/Equipment/images/230IndustrialMachine/230machine_threading_1.jpg)
 ![Successively down through the holes on the front plate, down to the tension plates, around and catch the tensioner wire, thread goes left. Under the hook, up and around the clip, through the machine bar, down around the left clip](/members/Equipment/images/230IndustrialMachine/230machine_threading_2.jpg)
 ![Into the thread guide, around into the opening at the back of the needle collar and down to the needle, and through](/members/Equipment/images/230IndustrialMachine/230machine_threading_3.jpg)
 
+
+## Maintenance
+### Maintenance log
+
+## Troubleshooting
+
 <!--stackedit_data:
 eyJoaXN0b3J5IjpbLTIwNDY2MDY5MTcsLTI1NTIyMzEzNiwtMT
 UxMzI3MTYyNiwtMTcxMDMwMTMzNywtMTU3ODY4NjU2OCw4OTY5