MCC generated code for i2c read and write operations with interrupts.

A code example that shows how to configure the ADCC to read a single analog value.

PIC18F47Q10 PWM Basic Configuration - bare metal

This repository provides a MCC-generated code example for using TMR0 in 8-bit Mode with clock output. A signal will be generated using TMR0 on the output RC2 pin.

The PIC18F47Q10 features two MSSP modules, which can be configured in SPI mode. In this demo, the SPI is configured as slave and it is used to exchange data. The data transfer is triggered by interrupts. The repository contains the bare metal code for the application.

PIC18F47Q10 PWM RGB-LED Using Interrupts - bare metal code example

The PIC18F47Q10 features two MSSP modules, which can be configured in SPI mode. In this demo, the SPI is configured as master and sends data to two slave devices, one at a time. The repository contains the Foundation Services Generated code for the application.

This repository provides an example of bare-metal code for GPIO read/write operations. This example shows how to read an input pin value, changed by pressing a button, and how to set an output pin value, in order to turn an LED on and off.

A code examples that shows how to configure the ADCC to read one analog value.

This repository provides an example of bare-metal code for a Wake-Up from Sleep procedure. This example shows how to obtain less power consumption by putting the device in the Sleep mode and waking it up using the IOC, with a button controlling the input pin value.

Bare metal code for i2c read and write operations with interrupts.

Foundation Services generated code for i2c write operation.

The PIC18F47Q10 provides multiple PORT modules. In this demo, a PORT pin is configured as input and connected to a button. The Interrupt-on-Change is enabled on the negative edge. Another pin is used as an output and connected to an LED.

This example shows how to send a string to the PC and see it in the MPLAB Data Visualizer Terminal.

Code example for "Getting Started with CLC on PIC18" Technical Brief : Using Basic Logic Gates - Bare Metal Code

A code example that configures the ADCC to provide an interrupt when a sharp increase or decrease is detected in the sampled value.

The PIC18F47Q10 features two MSSP modules, which can be configured in SPI mode. In this demo, the SPI is configured as slave and it is used receive data from a master device. The repository contains the MCC Generated code for the application.

This example shows how to use the printf function to send messages over EUSART and display charts in MPLAX Data Visualizer using Data Stream Protocol.

MCC generated code for i2c write operation

The PIC18F47Q10 features two MSSP modules, which can be configured in SPI mode. In this demo, the SPI is configured as slave and it is used to exchange data. The data transfer is triggered by interrupts. The repository contains the MCC Generated code for the application.