This is a simple tool to configure the Roxy and arcin boards.
The current version is available on the release page.
See the wiki for a description of the configuration options.
With either Roxy or arcin, there is the ability to flash a new firmware using the built-in bootloader. This bootloader may be activated via HID reports, or by holding Button 1 and Button 2 while plugging in the board.
Select an *.elf file to be loaded and press "Flash to Chip". If this button is not enabled, then the program has not detected an appropriate board.
NOTICE: Linux may not detect the board after it has been reset to bootloader via software. Use the "Check for Devices" button to manually force a re-enumeration of attached devices. The program will automatically flash once if it has been commanded to.
This program will not flash binaries that have already been combined into an *.exe. You should just use the *.exe.