hi2csend

HI2CSend

Syntax:

    HI2CSend data

Command Availability:

Only available for microcontrollers with the hardware I2C or TWI module.

Explanation:

The HI2CSend command will send data through the I2C connection. If in master mode, HI2CSend will send the data immediately. If in slave mode, HI2CSend will wait for the master to request the data before sending.

Note:

This command is also available on microcontrollers with a second hardware I2C port.

    HI2C2Send  data

Example:

This example code retrieves multiple bytes from an EEPROM memory device.

 do
      HI2CReStart                         ;generate a start signal
      HI2CSend(eepDev)                    ;indicate a write
    loop While HI2CAckPollState

    HI2CSend(eepAddr_H)                   ;as two bytes
    HI2CSend(eepAddr)
    HI2CReStart
    HI2CSend(eepDev + 1)                  ;indicate a read

    eep_i = 0                             ;loop consecutively
    do while (eep_i < eepLen)             ;these many bytes
      eep_j = eep_i + 1                   ;arrays begin at 1 not 0
      if (eep_i  < (eepLen - 1)) then
        HI2CReceive(eepArray(eep_j), ACK)  ;more data to get
      else
        HI2CReceive(eepArray(eep_j), NACK ) ;send NACK on last byte
      end if
      eep_i++                             ;get set for next
    loop
    HI2CStop

Supported in <HI2C.H>