-
Notifications
You must be signed in to change notification settings - Fork 126
Macro Configuration
Moggie edited this page May 25, 2024
·
4 revisions
This is where you'll likely spend most of your time tuning the MMU after the initial setup is done. It allows for configuration of all the supplied default macros in one place.
You will need to consult the Configuring mmu_macro_var.cfg reference page for full details, but essentially the file is broken up into sections where each section contains the configuration for the respective macro. These include:
Section | Macro Filename | Description |
---|---|---|
_MMU_SOFTWARE_VARS | base/mmu_software.cfg |
Controls the behavior of the print start and finalization |
_MMU_STATE_VARS | base/mmu_state.cfg |
Customization of behavior when state changes |
_MMU_LED_VARS | base/mmu_leds.cfg |
Configuration of LED actions |
_MMU_SEQUENCE_VARS | base/mmu_sequence.cfg |
Control the movement of the toolhead during a tool change |
_MMU_CUT_TIP_VARS | base/mmu_cut_tip.cfg |
Controls the tip cutting procedure |
_MMU_FORM_TIP_VARS | base/mmu_form_tip.cfg |
Control Happy Hare's implementation of tip forming |
_MMU_CLIENT_VARS | optional/client_macros.cfg |
Customization of Happy Hare's pause, resume and cancel_print macros |
- Hardware Configuration
- Happy Hare Parameters
- Macro Configuration
(\_/)
( *,*)
(")_(") Happy Hare Ready
Copyright (C) 2022-2024 Paul Morgan
1. Introduction
2. Installation
3. Essential Configuration
4. Calibration
5. Operation
-- YOUR MMU IS READY TO PLAY WITH --
6. Slicer-MMU Setup
-- NOW YOU ARE READY TO PRINT! --
7. Tuning
8. Optional Feature Setup
9. Advanced Configuration
10. Advanced Concepts
- State Persistence
- Statistics and Counters
- Tool and Gate Maps
- Filament Bypass
- Runout/Clog Detection
- Consumption Counters
- Synchronized Gear/Extruder
11. Quick References
12. Troubleshooting
13. FAQ
14. MCU Board Reference 🆕
15. Change Log
Happy Hare Discord