Skip to content

Macro Configuration

Moggie edited this page May 25, 2024 · 4 revisions

#f03c15 #c5f015 #1589F0 Macro Configuration (mmu_macro_vars.cfg)

This is where you'll likely spend most of your time tuning the MMU after the initial setup is done. It allows for configuration of all the supplied default macros in one place.

You will need to consult the Configuring mmu_macro_var.cfg reference page for full details, but essentially the file is broken up into sections where each section contains the configuration for the respective macro. These include:

Section Macro Filename Description
_MMU_SOFTWARE_VARS base/mmu_software.cfg Controls the behavior of the print start and finalization
_MMU_STATE_VARS base/mmu_state.cfg Customization of behavior when state changes
_MMU_LED_VARS base/mmu_leds.cfg Configuration of LED actions
_MMU_SEQUENCE_VARS base/mmu_sequence.cfg Control the movement of the toolhead during a tool change
_MMU_CUT_TIP_VARS base/mmu_cut_tip.cfg Controls the tip cutting procedure
_MMU_FORM_TIP_VARS base/mmu_form_tip.cfg Control Happy Hare's implementation of tip forming
_MMU_CLIENT_VARS optional/client_macros.cfg Customization of Happy Hare's pause, resume and cancel_print macros

More essential config setup:

 1. Introduction
 2. Installation
 3. Essential Configuration
 4. Calibration
 5. Operation

-- YOUR MMU IS READY TO PLAY WITH --

 6. Slicer-MMU Setup

-- NOW YOU ARE READY TO PRINT! --

 7. Tuning
 8. Optional Feature Setup
 9. Advanced Configuration
 10. Advanced Concepts
11. Quick References

12. Troubleshooting
13. FAQ
14. MCU Board Reference 🆕
15. Change Log

Clone this wiki locally